TRENDnet MultiTemp III 18-1106-33 - Manual (Page 27)

Short instructions
Note: The following short instructions are intended as a guide to
users who are fully familiar with safety procedures and
operating instructions described earlier in this manual.
1. Check to make sure that all tubings are firmly connected and
secured with hose clamps.
2. Check the liquid level and fill the bath if needed (the level
should be 2-4 cm below the lid).
3. Switch the power on at the mains switch.
4. Set the safety temperature limit using the dial on the rear
of the unit.
5. Set the setting range limit of the circulator (if required by the
application or any safety precautions).
6. Set the working temperature. Press to select the S mode
.
Use or to set the working temperature. Confirm with
before the display automatically returns to the actual
working temperature.
7. Set the temperature correction value if required.
Printed in Sweden by
TK i Uppsala, July 1997
A