Telular Phonecell SX5T CDMA2000 User Manual
Page 18
Phonecell
®
SX5T CDMA2000
14
User Manual
Call Restrict (SX5T-500C only)
Call Restrict allows you to determine which calls may or may not be placed through your SX5T. When
the Call Restrict level is set to
Use Table
, the Call Restrict feature checks outgoing calls against
user-defined permit and deny tables to determine whether to permit or deny the outgoing call. Each
table (permit and deny) may contain up to ten entries.
To set the Call Restrict level:
• From Configuration Mode, press
<1, 2, 3,
or
4>
,
where
<1, 2, 3,
or
4>
are as follows:
1 = No Restriction (default setting)
2 = Use Table
3 = Emergency Only
(only emergency calls permitted; all other calls denied)
4 = Clear Table
To set the Call Restrict table entries:
• From Configuration Mode, press
<0
or
1>
, where the options are as follows:
<0
or
1> = Table mode (0 = Deny table; 1 = Permit table)
(For example, if you wanted to add 555-123-4567 as the third entry in your Deny table, you
would press
)
Dial Tone After Remote Disconnect (DTARD)
To allow you to place another call when a connection has been terminated remotely (when the other
party has hung up the phone), you may elect to have the SX5T return to dial tone automatically. If you
elect not to enable DTARD, you will need to hang up the phone before placing another call.
To enable Dial Tone After Remote Disconnect (to return to dial tone):
• From Configuration Mode, press
.
To disable Dial Tone After Remote Disconnect:
• From Configuration Mode, press
.
Note:
If Dial Tone After Remote Disconnect is disabled, additional remote disconnect options may be
available. See “Disconnect Tone” on page 33 for more information.
#
0
*
8
*
#
#
1
*
8
*
#
#
7
6
5
4
3
2
1
5
5
5
*
3
*
0
*
6
4
1
*
#
#
*
*
*
6
4
1
*
#
#
*
5
4
1
*
#