Taylor 24 Hour Forecaster 1380 - Manual (Page 7)

7
Problem Solving
1. If the LCD readout is faint, replace the batteries.
2. If temperatures do not display on the base unit or seem irregular:
a) Check to see the cable is not crimped, severed or otherwise
damaged;
b) Relocate sensor probe if it is obstructed from weather condi-
tions or in contact with an object that might affect temperature
readings (hot metal object, snow, etc.)
c) Remove and reinstall all batteries, using new fully charged bat-
teries;
d) Repeat set-up procedures;
3. If new batteries are faulty on the initial installation, install fresh
batteries. If you did not notice the Low Battery icon warning and
the product performed correctly after initial set up, the batteries
have lost their charge. Replace the batteries (see To Power up
Weather Forecaster).
Display Information
If the receiver unit does not receive a transmission from the sensor
probe for 1 hour, the display will show dashes. Remove and reinstall
all batteries and repeat set up procedures. Check to see that the
cable is not crimped or severed and the sensor is not obstructed.
Try various locations for the sensor probe if necessary.
Over- or under- temperature range displays:
If the temperature is outside the unit’s temperature range of -40°F
to 158°F / -40°C to 70°C (with use of lithium batteries), the LCD will
show “HH” (higher than the temperature range) or “LL” (lower than
the temperature range). When temperatures are within the range,
the readings will return. If necessary, relocate the sensor probe
away from locations with extreme temperatures (such as snow or
a hot surface).
Keyhole
Table stand
ºC/ºF Button
Battery
Compartment
Back View
Placement:
Table stand –
Use to sit the base unit
on a flat surface, such
as a desk or countertop.
Keyhole –
Use to hang on a wall.