Technicolor - Thomson RCR311B - Manual (Page 5)

5
VCR • DVD
VCR • DVD
ON • OFF
VCR • DVD
ON • OFF
SAT • CBL
a. Press and hold the VCR•DVD
key. The illuminated ON•OFF
key turns on.
b. While holding down the
VCR•DVD key, press and release
the number 2 key on the keypad
to control a VCR or the number 3
key to control a DVD. The
illuminated ON•OFF key blinks,
and then turns back on.
c. Release the VCR•DVD key. The
illuminated ON•OFF key blinks
four times and then turns off.
Your remote is now either in
VCR or DVD Programming
Mode, depending on which
you chose. Proceed to step 5.
5. Press and hold the component key
(TV, VCR•DVD, SAT•CBL) you wish
to program. The illuminated ON•OFF
key turns on and remains on.
6. While holding the component key
down, press and hold the ON•OFF
key. The illuminated ON•OFF key
turns off.
7. After holding both keys down for
three seconds, the illuminated
ON•OFF
key turns back on.
8. Release both keys. The illuminated
ON•OFF key remains on.
9. Refer to the Brand Codes in the
enclosed Code Lists. Press and
release the appropriate brand code
key (Numbers 0-9), using the number
keys on the keypad. The illuminated
ON•OFF
key blinks once.
TIP: Throughout the programming
of each key, be sure to keep the remote
pointed at the IR sensor of the component
you are currently programming the
remote to control.
10. Press and release the ON•OFF key
repeatedly until your component
turns off. Each time you press the
ON•OFF
key, the illuminated ON•OFF
key blinks, and the next code is
sent. The Brand Code Search begins
with the first code in the chosen
brand list for that component and
cycles through all the codes for that
brand. If your component turns off,
you have found the correct code. (If
it cycles through and the illuminated
ON•OFF
key blinks four times and
turns off, all codes in the chosen
VCR • DVD
TV
ON•OFF
(BLINK)
ON•OFF
(BLINK)
ON•OFF
(BLINK)
Brand Code Search key (TV, VCR•DVD, SAT•CBL, ON•OFF,
GO BACK
, and number keys 0-9), the search times out after
two minutes. When the search times out, the illuminated
ON•OFF
key blinks four times and turns off. The last
programmed code under that component key is retained.
3. If you are programming the remote to control your TV,
satellite receiver or cable box, go directly to step 5.
4. To program the remote to control a VCR or DVD. The
VCR•DVD key can control only one component, either your
VCR or your DVD. To program your remote to control either
your DVD or your VCR, you must first put the remote in the
proper programming mode. Follow these directions before
proceeding to step 5.
ON•OFF
ON•OFF
(BLINK)