Dip switch functions, Dip switch functions - 1 – Toshiba B-450-QQ Series User Manual
Page 10
4-1
4. DIP SWITCH FUNCTIONS
EO1-33006
The DIP switches are located at the rear of the printer.
4. DIP SWITCH FUNCTIONS
NOTES: 1.
DIP Switch settings are read at power on time.
2.
To enter the program download mode first set DIP SW #8 to ON. The printer will then enter
down the [FEED] or [FEED] and [PAUSE]
keys whilst turning the power on. If the printer
is turned on without pressing a key, it will enter the program download mode.
Do not set the switches to the maintenance mode as this may cause a failure.
3.
When DIP SW#8 is set to OFF, the backing paper thickness setting can be changed by
the following combination of DIPSWs #6 and #7.
DIP SW
Fig. 4-1
WARNING!
Turn the POWER OFF before
changing the DIP switches.
DIP SW
No.
1
2
3
4
5
6
7
8
ON/OFF
1
OFF
ON
OFF
ON
2
OFF
OFF
ON
ON
OFF
ON
OFF
ON
OFF
ON
6
OFF
ON
OFF
ON
7
OFF
OFF
ON
ON
OFF
ON
Function
2400 bps
4800 bps
9600 bps
19200 bps
None
EVEN
Not available
Available
Available
Not available
RAM clear mode (Maintenance counter)
Threshold manual setting mode
Sensor adjustment mode
RAM clear mode (Parameter)
Normal operation mode
Program down load operation
Remarks
Transmission speed
(Baud rate)
Parity
Stacker
Auto media feed
Selectable only when
DIP SW #8 is ON.
Operating mode
No.6
OFF
ON
No.7
OFF
OFF
Thickness of Backing Paper
70
µ
m Thin Backing Paper
80
µ
m Thick Backing Paper
the relevant modes, as selected by DIP SWS #6 and #7. To initialize these modes hold