Identification of controls (continued) – Toshiba MW20FP3 User Manual

Page 12

Introduction

Operation:
• Aim the remote control at the remote sensor and press control buttons to

operate.

• Operate the remote control within 30

angle on either side of the remote

sensor, up to a distance of approx. 5 meters.

Replace the compartment cover.

Install two “R03/AAA” batteries
(supplied), paying attention to
the polarity diagram in the
battery compartment.

Slide the battery compartment
cover in the direction of the
arrow.

Battery precautions:

The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-

versed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from

possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery

manufacturer’s directions.)

• Press POWER to turn the unit on or off.
• Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
• Tap CHANNEL

or to move through the channels one channel at a time.

• The Direction buttons ( / /

) are also used to navigate on-screen menu system.

• You can directly access specific channels using Direct channel selection buttons.

Remote control basics

Inserting batteries

Approx. 5 meters

Identification of controls (continued)

Illustration of MW20FP3

5L00301C [E]p06-12

20/4/04, 16:12

This manual is related to the following products:

MW24FP3