SUUNTO Cobra2 - Manual (Page 21)

5.8.5. Setting the sample rate
The sample rate controls how often the depth, time, tank pressure, and water temperature
is stored in the memory. You can set the dive profile sample rate to 1, 10, 20, 30, or 60
seconds. The factory default setting is 20 seconds.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.8.6. Setting the Safety Stops/Deep Stops
The Deep Stop setting allows you to choose between traditional Safety Stops or Deep
Stops. If Deep Stops are set to OFF, only the traditional Safety Stop calculation is used.
If set to ON, iterative Deep Stops will be prompted aswell. The length of the individual
Deep Stops can be set to 1 or 2 minutes.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.8.7. Setting the RGBM values
For certain divers and diving conditions, it may be desirable to set the attenuated RGBM
mode. The selection is displayed during the DIVE mode startup. The options are full RGBM
effects (100%), and attenuated RGBM (50%).
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.9. Activation and pre-checks
This section describes how to activate the DIVE mode and explains the pre-checks that
it is highly recommended you perform before you get into the water.
5.9.1. Accessing DIVE mode
The Suunto Cobra2 has three diving modes: AIR mode for diving with standard air only,
NITROX mode for diving with oxygen enriched mixtures, and GAUGE mode for use as a
bottom timer. The OFF mode disables the DIVE mode, and allows the TIME mode to be
used underwater. The chosen dive mode is displayed when the DIVE mode is accessed,
and you can toggle between the submodes by pressing the UP/DOWN buttons.
21