SUUNTO Cobra2 - Manual (Page 16)

5. BEFORE DIVING
Do not attempt to use the dive computer without reading this user's manual in its entirety,
including all the warnings. Make sure that you fully understand the use, displays, and
limitations of the instrument. If you have any questions about the manual or the Suunto
Cobra2 please contact your Suunto representative before diving with the dive computer.
Always remember that YOU ARE RESPONSIBLE FOR YOUR OWN SAFETY!
When used properly, Suunto Cobra2 is an outstanding tool for assisting properly trained,
certified divers in planning and executing sport dives. It is NOT A SUBSTITUTE FOR
CERTIFIED SCUBA INSTRUCTION, including training in the principles of decompression.
WARNING Diving with enriched air mixtures (nitrox) exposes you to risks that
are different from those associated with diving with standard air. These
risks are not obvious, and require training to understand and avoid.
Risks include possible serious injury or death.
Do not attempt to dive with any gas mix other than standard air without first receiving
certified training in this specialty.
5.1. The Suunto RGBM/Deep Stop Algorithm
Suunto’s Reduced Gradient Bubble Model (RGBM), utilized in the Suunto Cobra2, predicts
both dissolved and free gas in the blood and tissues of divers. It is a significant advance
on the classic Haldane models, which do not predict free gas. The advantage of Suunto
RGBM is additional safety through its ability to adapt to a variety of situations and dive
profiles.
The Suunto Cobra2 uses traditional recommended safety stops as well as deep stops.
YOU ARE ADVISED TO MAKE A
DEEPSTOP AT 18 M. THE SECOND
INDICATOR SHOWS THAT YOU HAVE 110
SECONDS LEFT OF YOUR DEEPSTOP.
In order to optimize the response to different increased risk situations, an additional category
of stop, referred to as a Mandatory Safety Stop, has been introduced. The combination
of stop types depends on the user settings and the specific dive situation.
To get the most from the RGBM safety benefits, refer to Section 9.2. RGBM.
5.2. Emergency ascents
In the unlikely event that the dive computer malfunctions during a dive, follow the emergency
procedures provided by your certified dive training agency or, alternatively, follow these
steps:
1.
Assess the situation calmly and then move promptly to less than 18 m/60 ft.
2. At 18 m/60 ft, slow down your ascent rate to 10 m/33 ft per minute and move to a
depth between 3 and 6 m/10 and 20 ft.
3. Stay there for as long as your air supply will safely allow. After reaching the surface,
do not dive for at least 24 hours.
5.3. Dive computer limitations
While the dive computer's calculations are based on current decompression research and
technology, it is important to realize that the computer cannot monitor the actual
physiological functions of an individual diver. All decompression schedules currently known
to the authors, including the U.S. Navy Tables, are based on theoretical mathematical
models, which are intended to serve as a guide to reduce the probability of decompression
illness.
16