SUUNTO Cobra2 - Manual (Page 19)

5.7.1. Connecting Suunto Cobra2 to a regulator
When purchasing the Suunto Cobra2, we strongly recommend that you have your Suunto
representative attach it to the first stage of your regulator.
However, if you decide to attach it yourself, follow the steps outlined below:
1.
Remove the high pressure (HP) port plug on the first stage of your regulator using an
appropriate tool.
2. Thread the high pressure hose of the Suunto Cobra2 into the HP port of your regulator
with your fingers. Tighten the hose fitting with a 16 mm (5/8'') wrench. DO NOT
OVERTIGHTEN!
3. Attach the regulator to the scuba cylinder and slowly open the valve. Check for leaks
by submerging the regulator first stage in water. If leaks are detected, check the
condition of the O-ring and sealing surfaces.
5.8. DIVE mode settings
Suunto Cobra2 has several user-definable functions, as well as depth and time-related
alarms that you can set according to your personal preferences. The DIVE mode settings
are dependent on the dive sub-mode chosen (AIR, NITROX, GAUGE), so that, for example,
nitrox settings are only available in the DIVENitrox sub-mode.
The following figure shows how to enter the DIVE mode settings menu.
USE UP AND DOWN BUTTONS TO
TOGGLE BETWEEN DIVE SETTINGS
NOTE The settings cannot be activated until 5 minutes has elapsed after
the dive.
5.8.1. Setting the depth alarm
You can set a depth alarm in the dive computer.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
The depth alarm is factory-set to 30 m/131 ft, but you can adjust it according to your
personal preference, or switch it off altogether. The depth range can be set from 3m to
100 m/9 ft to 328 ft.
5.8.2. Setting the dive-time alarm
The Suunto Cobra2 has a dive-time alarm setting which, when activated, can be used for
several purposes to add to your diving safety.
19