Toshiba 510D - Manual (Page 2)

1) If the server is in operation, shut it down, switch
off the power, and unplug the power cable.
2) Remove memory modules as needed to observe
the 1,7 MB limit.
3) Install Windows NT Server 4.0 and Windows NT
4.0 Service Pack with the memory capacity at less
than 1,7 MB.
4) After installing Windows NT server 4.0, please
replace memory that is above than 1,7 MB.
For installing and removing the memory modules,
refer to MAGNIA User’s Guide
(on the Documentation CD ROM), Chapter 2.
(3) Installing Windows NT Server 4.0 to the server
with an MO device.
Using an MO device with this server may prevent the
correct installation of Windows NT Server 4.0. In this
case, remove the MO device before installing
Windows NT Server 4.0. As a precaution, replace the
server’s panels before switching it on. For installing
and removing the MO device, refer to MAGNIA
User’s Guide (on the Documentation CD ROM),
Chapter 2.
(4) Network adapter setup
1)Check the connector panel on the Network
adapter to see if the "530LTX" label is attached.
2)Enter the following settings in Network adapter’s
propaties when the Network adapter has been
installed from the floppy disk or when the Network
adapter properties have been selected on the
control panel network.
2/15 S00047-EN EH02 Rev. E