Technicolor - Thomson IB5400GB - Manual (Page 26)

26
S
peakers
From the “AUDIO OPTIONS” menu you can access all
the settings. Follow these intructions:
1. Move to the items and press ok (15) to confirm
and select the value to be adjusted and press
ok ( 15 ) to confirm.
2. To save your settings when you have finished,
press
return key ( 20 ). (Otherwise, all the original
settings are restored.)
Speaker setting principle
System audio quality
Depending on the amplifier and connected speakers, confirm your set-up with the menu below.
This interactive menu page allows you to,
• Select the speakers you have connected.
• Adjust their audio volume and respective delay.
• Configure all the decoding values for the Dolby Digital and multichannel MPEG 2 audio for your
speakers.
• Display the room with the position and number of speakers (including the subwoofer).
• Choose the size and quality of your speakers by clicking twice on each speaker (function available
for Dolby Digital DVD discs only).
• Adjust the delay between the front and surround speakers, and for the central speaker according to
its position compared to the front speakers.
• Test the setting by running a test sound (“pink noise”).
If you do not have the 5 recommended speakers (+1: the Subwoofer) for multichannel surround
sound,
• Click twice on the icon corresponding to your missing speakers (subwoofer and/or surround
speakers): they disappear from the screen. Multichannel sound will now be distributed across the
remaining speakers. As you purchase more speakers, you can re-activate them one by one.
Surround (L/R)
Delay time
Test
0
dB
0
dB
0
cm
0
dB
0
dB
0
cm
SPEAKER SETUP
RETURN ¹ ¹ Г Г ¨ ¨ OK
Surround (L)
Large/Small/None
Surround (R)
Large/Small/None
Front (R)
Large/Small
Center
Distance
Subwoofer
Yes/No
Center
Volume
Centre
Large/Small/None
Front (L)
Large/Small
Surround (L/R)
Distance / volume
➮ Underlined item is the factory setting.
Speaker setting is required only if you use the 6 RCA phono sockets on the rear of the DVD player.
In that case, the Dolby Digital / MPEG-2 decoder sends a decoded 5.1 signal to the amplifier (for
further information, refer to page 10). Speaker setting is required only at installation.
IB5400GB 3/09/01 16:14 Page 26