Toshiba 15VL63c - Manual (Page 7)

ENGLISH -8-
Please Note: When not in use disconnect the
plug
from the mains power supply.
Please Note: Do not leave the television in
standby unattended or overnight.
Switching the TV on for the first time
To install your TV, please read the sections
“TV controls” and “Tuning the television”.
The batteries
Remove the back cover of your remote control to
reveal the battery compartment and make sure
you insert the batteries the right way round.
Suitable battery types for this remote are IEC
R03 or AAA 1.5V.
Do not throw your old batteries into a fire, dispose
of them in a designated disposal area.
Do not combine a used, old battery with a new
one or mix battery types.
The performance of the remote control will
deteriorate beyond a distance of 8 metres or
outside an angle of 30 degrees from the centre
of the TV.
Getting started
Remove your Television carefully from the box.
You may wish to store the packaging for future
use.
In the box
Inside the carton box you should have:
• Accessories box
• Power cord
• Adapter
• Remote control
• Batteries
Note: Scart, VGA and RCA leads are not supplied.
Aerial connection
To connect an aerial, plug the aerial lead
into the aerial socket on the rear of the TV.
You can use an outdoor or indoor aerial.
However, if you use an indoor aerial the quality
of the reception may be reduced and adjustment
of the aerial may be required when changing
programs.
Please note: If you live in a poor reception
area or use an indoor aerial you may experience
loss or corruption of teletext transmissions.
Switching on and First Use
1. Connect the power cord to the mains plug.
2. Connect the input socket of the adapter to
the DC socket at the back panel of the LCD
TV.
3. Connect adapter to the mains plug.
Note 1: Your TV will move to stand-by mode
in five minutes when there is no broadcast signal.
Note 2: Your TV is equiped to operate with
front panel buttons, “MENU”, “ ”,
“- +” in case your R/C is broken or the
batteries are exhausted.
4. Press the Stand-by button on the
under side of the TV, indicated by
the “ /I) symbol. The stand-by
indicator will turn red.
5. Press a Numeric button or the
( ) or ( ) button on the remote
handset or ( ), ( ) or (MENU)
button on the top panel to switch
the TV on.
The standby indicator changes from
Red to Blue.
The picture will appear after a few
seconds.
Press the ( ) button on the remote
control to switch the TV to stand-by .
The stand-by indicator will change from
blue to red.
15VL63