Toshiba 15DLV16 - Manual (Page 17)

17
Connections
Connecting to an optional equipment with S-video output
If you connect a VCR with an S-VIDEO cable to the S-VIDEO IN jack on the left side of the TV/DVD, you must
also connect the audio cables to the AUDIO IN (LINE 2 IN) jacks on the left side of the TV/DVD. The S-VIDEO
cable only carries the video signal. The audio signal is separate.
Select the “VIDEO2” by pressing INPUT SELECT repeatedly.
Note: When the S-VIDEO cable and the standard video cable are connected at the same time, the S-video cable takes precedence.
Left side (LINE 2 IN)
Ex. VCR with S-Video
To S-VIDEO OUT To Audio (L/R) OUT
To S-VIDEO IN
Audio cable (not supplied)
S-Video cable (not supplied)
Connecting an optional equipment with ColorStream ® (Component video) output
Your TV/DVD is capable of using ColorStream ® (component video). Connecting your TV/DVD to a component
video compatible DVD player, such as a Toshiba DVD player with ColorStream ® can greatly enhance picture
quality and performance.
The ColorStream ® inputs on this unit are for use with devices that output 480i interlaced signals and 480p progressive signals.
This unit will not accept or display 720p progressive scan signals or 1080i interlaced high-definition signals. If you connect a high-
definition set-top receiver, 720p progressive scan DVD player, or other similar device to the unit’s ColorStream
® inputs, YOU MUST
SWITCH THE DEVICE’S OUTPUT TO 480i INTERLACED OR 480p PROGRESSIVE MODE FIRST. Failure to do this will cause a
poor or no picture to display.
Rear lower right of the TV Ex. DVD player with Component video
Audio cable (not supplied)
Component video cable (not supplied)
To Audio OUT To Component
Video OUT
To AUDIO (L/R) IN
To COMPONENT
(Y, P
B,
P
R
) IN
■ Selecting Component input mode
Press INPUT SELECT repeatedly to
select “ColorStream” mode.
When using the Component video cable,
an Audio cable must be connected to
AUDIO IN (L/R) (LINE 1 IN) jacks.
ColorStream
Notes:
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet
before making any connections.
• If you place the unit near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the unit away from the
tuner and radio.
: Signal flow
: Signal flow
(playback)
(red)
(white)
To AUDIO (L/R) IN
J5X00301A [E] (P14-25) 16/3/06, 3:47 PM 17