Tripp Lite NetDirector B060-032-8 - Manual (Page 40)

40
Setting Description
SET SCAN
SCAN INTERVAL – Determines how long a KVM port is displayed for while in Auto Scan mode. Enter a value from 0-240
seconds and press the Enter key. The default is 5 seconds. A value of zero will automatically enter the B060-032-8 into Skip
Mode when Auto Scan is initiated.
SCAN MODE – Selects which computers will be accessed during an Auto Scan.
- PERSONAL – Scans only those KVM ports the user has set as personal.
- ACCESSIBLE – Scans only those KVM ports that the user has been given access to.
- ACCESSIBLE & POWERED – Scans only those KVM ports that the user has been given access to and that are powered on.
The default is ACCESSIBLE & POWERED.
11. OSD Operation
F3: SET
This function allows users to change their account passwords and set up and adjust their personal settings. A separate profi le for each user is stored by the
OSD and is activated according to the username that is provided during log in. The settings are explained in the following table:
Setting Description
CHANGE PASSWORD
Enables the user to change their account password. When changing their password, the user will be required to type in the old
password, and then type in the new password twice. To confi rm the changes press the Enter key, which will bring you back to
the previous screen. Blank passwords are acceptable.
OSD ACTIVATION The user can select which Hotkey they wish to use, SCROLL LOCK or CTRL. This setting defaults at Scroll Lock.
SET LOGOUT This setting allows the user to determine how much inactive time must pass before they are logged out of the B060-032-8,
TIMEOUT requiring them to enter their password to regain access to the KVM switch. The user can enter a time from 1-180 minutes,
with zero deactivating this setting. This setting defaults at zero (disabled).
SCREEN BLANKER This setting allows the user to determine how much inactive time must pass before the users screen goes blank, requiring
mouse activity to display the screen again. The user can key in a time from 1-30 minutes, with zero disabling this setting. This
setting defaults at zero (disabled).
HOTKEY COMMAND This setting allows the user to enable/disable the Hotkey command mode. When disabled the user will need to access KVM
MODE ports or perform functions solely via the OSD. This setting defaults at enabled.
SET BEEPER This setting allows the user to turn the beeper On/Off. This setting defaults at On.
IDLE TIMEOUT This setting allows the user to determine the amount of inactive time before the KVM port they are accessing is released for
use by other users. The user can set a time from 1-240 seconds, with zero disabling this setting. This setting defaults at 5
seconds.
RESTORE USER
This allows the user to restore the original factory default settings for the View and Set menus of their user profi le.
DEFAULT Note: Password is not affected.
F4: ADM
F4 is accessible only by Super Administrators and Administrators. It allows confi guration and control of the overall operation of the OSD. Note: When
creating user accounts, each user must be added to a group. It is recommended that groups be created before user accounts. If you do not wish to create
groups you may add users to the default group account; however, the default group account cannot be used to grant port access to group members. In this
case, you must individually add users to the KVM port(s).