Telenetics Sunrise Series Modular Nest - Manual (Page 28)

Part No. TEL–09949, Rev A
June 2001
Removing and Installing a Backplane in Modular Nest 9 or 21 Enclosure Page 28 of 34
Removing a 326X Backplane
Caution
Power down the unit before you begin.
To remove a backplane from a Modular Nest 9 or 21 enclosure (Figure 14):
1) Ensure that the enclosure is powered down.
2) Remove all cards from the front of the enclosure.
3) Using a flat-blade screwdriver, unfasten the backplane connectors.
4) Pushing up from beneath the connectors near the top of the
backplane, lift the backplane vertically, very slightly, to disconnect it
from the power distribution connector (A).
5) Tilt the top of the backplane away from the enclosure (B), and
remove the backplane (C).
6) Power up the enclosure.