5 installing the software gui and usb driver, Prompt – Texas Instruments SCAU020 User Manual
Page 8
www.ti.com
5
Installing the Software GUI and USB Driver
Installing the Software GUI and USB Driver
The CDCE421EVM software can be installed on a PC running the Microsoft Windows
®
2000 operating
system or higher (including Windows XP
®
).
To start software installation, run the ChronosSetup.msi file (available on the CD shipped with the EVM).
appears. Be sure to note the installation folder; the USB driver must be installed in the same after
setup completes and the USB cable is connected. See
Figure 3. Software Installation Screen
Note the program file location; the USB controller driver is in the same location.
Figure 4. Installation Prompt
8
10.9MHz–1175MHz Low Phase Noise Clock Evaluation Board
SCAU020 – March 2007
See also other documents in the category Texas Instruments Hardware:
- Digital Signal Processor SM320F2812-HT (153 pages)
- MSP430x1xx (440 pages)
- Laser And Motor Drives DRV8811EVM (13 pages)
- TMS320 DSP (88 pages)
- MSP430x11x1 (45 pages)
- TVP5154EVM (55 pages)
- TMS320DM646X DMSOC (64 pages)
- CC2511 (24 pages)
- SN65HVS880 (4 pages)
- TPS650231EVM (14 pages)
- TMS320TCI648x (256 pages)
- TSC2007EVM-PDK (16 pages)
- UCC38500EVM (16 pages)
- TMS320C6000 (62 pages)
- TPS40051 (17 pages)
- TNETE2201 (14 pages)
- TMS320C64x DSP (306 pages)
- UCC2891 (21 pages)
- TMS320C3x (757 pages)
- MSP430 (138 pages)
- TMS320C6712D (102 pages)
- MSP430x4xx (512 pages)
- TMS320C6454 (225 pages)
- SPRU938B (48 pages)
- TUSB3210 (22 pages)
- TMS320C6457 (43 pages)
- CC2530ZNP (3 pages)
- TMS320C6455 (50 pages)
- TSB12LV26 (91 pages)
- TMS320C6472 (2 pages)
- VLYNQ Port (49 pages)
- TMS380C26 (92 pages)
- MSP-FET430 (95 pages)
- TMS320TCI6486 (160 pages)
- TPS2330 (22 pages)
- DM648 DSP (47 pages)
- TMS320DM36X (134 pages)
- MSC1211 (35 pages)
- SPRAA56 (29 pages)
- DAC7741EVM (28 pages)
- CDCM7005 (34 pages)
- TMS370 (99 pages)
- Adpater (37 pages)
- TMS320C6452 DSP (46 pages)