Tekkeon MP1500 User Manual
Page 6
Installing Batteries
myPower GO requires four rechargeable
or alkaline AA batteries, which are
housed on the bottom side of the unit.
As myPower GO doubles as a battery
charger, rechargeable batteries can be
recharged in the unit.
(Please note that alkaline and rechargeable batteries should not be used together.)
1. Push down on the lever above
the USB port, slide the cover in
the direction of the arrow, and
then lift the cover to remove
(as shown).
2. Insert the batteries in the
directions indicated.
3. Replace the cover.
4. Press the TEST button. All LEDs will light to indicate the batteries are installed
properly. As the batteries are drained to charge your portable device(s), the LEDs
will turn off in sequence.
4
Push down
Slide cover forward
and lift
mp1500_ug_revC_fnl 3/12/07 3:34 PM Page 4