beautypg.com
Page 9 of 24
5.2. Crosspoint Gain
Set the crosspoint switch gain. 9000Series Amplifier responds with the same data as that
received.
This command is enabled when in the mixer mode only.
Note: Command cannot be received during power off.
95H, 05H, , , Channel Attribute>, , 00H: Input channel 00H - 07H (Input channel 1 - 8) 01H: Output channel 00H – 07H (Output channel 1 - 8) 00 - 51H: Gain Position (-∞ to +10.0 dB) 60 - 6FH: Position Down (1 – 16dB Step Down) 70 - 7FH: Position Up (1 – 16dB Step Up) Example 1: Setting the crosspoint gain from Input Channel 1 to Output Channel 1 to a fixed value of 0 dB 95H, 05H, 00H, 00H, 01H, 00H, 47H Example 2: Increasing the crosspoint gain from Input Channel 1 to Output Channel 1 by +3.0 dB steps 95H, 05H, 00H, 00H, 01H, 00H, 72H See Crosspoint Gain Table on the next page.
Channel Attribute>, ,
00H: Input channel
00H - 07H (Input channel 1 - 8)
01H: Output channel
00H – 07H (Output channel 1 - 8)
00 - 51H: Gain Position (-
∞
to +10.0 dB)
60 - 6FH: Position Down (1 – 16dB Step Down)
70 - 7FH: Position Up (1 – 16dB Step Up)
Example 1: Setting the crosspoint gain from Input Channel 1 to Output Channel 1 to a fixed
value of 0 dB
95H, 05H, 00H, 00H, 01H, 00H, 47H
Example 2: Increasing the crosspoint gain from Input Channel 1 to Output Channel 1 by
+3.0 dB steps
95H, 05H, 00H, 00H, 01H, 00H, 72H
See Crosspoint Gain Table on the next page.