Adjusting standard duty cut height, Maintenance, Adjusting the cutting height – Tiger JD 5101E User Manual
Page 74
Side & Rear flail Maintenance Section 4-16
MAINTENANCE
ADJUSTING STANDARD DUTY CUT HEIGHT
To adjust the cutting height of the standard duty flail head the two nuts on the roller
shaft brackets must be taken off and moved to the desired location / height. See
diagram below. Be sure that both sides of the shaft are adjusted to corresponding
holes so the shaft remains level.
ADJUSTING THE CUTTING HEIGHT
Loosen the four ground roller bracket lock nuts. Loosen the adjustment rod
lock nut and turn the adjustment rod to adjust the cutting height. The cutting
height is indicated by the end of the adjustment rod on the cutting height decal.
When cutting height has been achieved, tighten the ground roller bracket lock nuts
and the adjustment rod lock nut securely. Be sure both sides of the flail are
adjusted the same.