Telex Firefly P200 - Manual (Page 28)

PROBLEM POSSIBLE SOLUTIONS
Split image or partial image
•
Image alignment needed; use up-down and left-right arrow keys.
•
Incompatible video signal from computer.
•
Reset the Firefly ™ to factory default settings.
Power button not illuminated on keypanel
•
Firefly ™ not connected to AC wall outlet.
•
Defective AC wall outlet.
No audio from built-in speakers
•
No audio source connected.
•
Firefly ™ not turned on.
•
Firefly ™ not connected to AC wall outlet.
•
AC wall outlet defective.
•
Audio source turned off.
•
Audio source not connected with appropriate video input.
•
Audio source and audio output cables are reversed.
•
Volume control is set too low.
•
External amplified speaker system connected to the AUDIO OUT jack.
Visible bright spots
•
An inactive pixel may appear as a bright spot on the screen, however,
it will not affect picture quality or the life expectancy of the P200/P250.
(The Firefly
™ P200/P250 may contain a maximum of 50 inactive
pixels.)
Image contains one or more vertical bars
•
Use the Menu Mode On-Screen Controls to adjust the WIDTH . (After
eliminating the vertical bars, use FOCUS to sharpen the image.)
NOTE: When adjusting the WIDTH , if the left arrow adjustment
causes the number of bars to increase, use the right arrow adjustment
to eliminate the bars. If the right arrow adjustment causes the number
of bars to increase, use the left arrow adjustment to eliminate the bars.
☞
User Manual 23