Telex Firefly P200 - Manual (Page 21)

Menu Mode On-Screen Controls
INVERSE To access the INVERSE function, press and release MENU , then press
either the up or down arrow key to “step” through the “menu” until
INVERSE is displayed. Press either the right or left arrow key to switch
between a positive and negative image. An on-screen graphic will
indicate the
INVERSE setting.
WIDTH To access the WIDTH function, press and release MENU , then press
either the up or down arrow key to “step” through the “menu” until
WIDTH is displayed. Press the right arrow key to expand the width of
the image. Press the left arrow key to contract the width of the image.
An on-screen graphic will indicate the relative value of the
WIDTH
setting. WIDTH may affect the FOCUS control, refer to the
Troubleshooting Guide.
FOCUS To access FOCUS function, press and release MENU , then press either
the up or down arrow key to “step” through the “menu” until FOCUS is
displayed. Press either the right or left arrow key to select between eight
possible image phase adjustment settings. An on-screen graphic will
indicate the
FOCUS setting. FOCUS can be affected by the WIDTH
control, refer to the Troubleshooting Guide .
MIRROR To access the MIRROR function, press and release MENU , then press
either the up or down arrow key to “step” through the “menu” until
MIRROR is displayed. Press either the right or left arrow key to switch
between the standard or mirror (reverse) image. An on-screen graphic
will indicate the
MIRROR setting.
PALETTE To access the PALETTE function, press and release MENU , then press
either the up or down arrow key to “step” through the “menu” until
PALETTE is displayed. Press either the right or left arrow key to switch
between one of two color modes: 8-color or 16,194,277-color. An
on-screen graphic will indicate the
PALETTE setting.
TINT To access the TINT function, press and release MENU , then press
either the up or down arrow key to “step” through the “menu” until TINT
is displayed. Press the right arrow key to increase the red in the color
image. Press the left arrow key to increase the green in the color image.
An on-screen graphic will indicate the relative value of the
TINT setting.
TONE To access the TONE function, press and release MENU , then press
either the up or down arrow key to “step” through the “menu” until TONE
is displayed. Press the right arrow key to increase the high tones in the
speaker output. Press the left arrow key to decrease the high tones in
the speaker output. An on-screen graphic will indicate the relative value
of the
TONE setting.
16 User Manual