True Manufacturing Company TCGR-50 - Manual (Page 10)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
8 8
A. The compressor is ready to operate. Plug in the
display case.
B. Check the temperature control setting in the lower
right of the cabinet backside. The setting should
be at No. 3 position to maintain an approximate
temperature of 38°F (3.3°C). Set defrost time clock
to the correct time of day. Allow unit to function
several hours, completely cooling cabinet before
changing the control setting.
C. Excessive tampering with the control could lead to
service difficulties. Should it ever become necessary
to replace temperature control, be sure it is ordered
from your TRUE dealer or recommended service
agent.
D. Good air flow in your TRUE unit is critical. Be
careful not to overstock product or block air vents.
E. Verify that the cabinet lights are working. Bakery
cases are shipped with light switches in the "on"
position. The toggle switch is located lower right
corer at the rear.
NOTE
If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE
unit empty for two to three days. This allows you to be sure
electrical wiring and installation are correct and no shipping
damage has occurred. Remember, our factory warranty
does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for
your unit. If at any time during the life of your display case,
a part is needed, you may obtain this part by furnishing
the model number and serial number to the company from
whom you purchased the cabinet. Call Toll-Free: (800)-424-
TRUE (Direct to Parts Department). (800)-325-6152 (U.S.A.
& Canada only) or call: (636)-240-2400.
STARTUP
INSTALLATION / OPERATION INSTRUCTIONS
REFRIGERATED CURVED GLASS
DISPLAY CASES
Hard wired Display Cases are equipped with
a service receptacle (found on the upper right
cabinet backside). No electrical load greater
than 4.0 amps should be connected to it.