Sms (short messages service) – Topcom FIDELITY SMS User Manual
Page 10
10
Topcom Fidelity SMS
8.3 Calling a number a Direct Memory number
•
Press the desired Direct Memory key, the stored number is displayed.
•
In case you select the VM number, the number is dialled out automatically in handsfree.
•
For the other Direct Memories, press handsfree or pick up the handset.
8.4 Changing a number and name of a Direct Memory
The VM Direct Memory cannot be changed or erased only overwritten.
•
Press the desired Direct Memory key, the stored number is displayed.
•
Press OK to confirm
•
Use the scroll switch to select ‘Edit?’.
•
Press OK to confirm.
•
Edit the telephone number when necessary.
•
Press OK to confirm
•
Use the scroll switch to select ‘Save M1,M2...?’.
•
Press OK to confirm.
•
Press the desired Direct Memory key (M1, M2, M3 or VM), ‘Saved’ appears on the display.
8.5 Erasing a number and name from the Direct Memory
•
Press the desired Direct Memory key, the stored number is displayed.
•
Press OK to confirm
•
Use the scroll switch to select ‘Clear?’.
•
Press OK to confirm.
9. SMS (SHORT MESSAGES SERVICE)
To use SMS, this service has to be activated on your phone line. Normally you need to call a special number
to get a subscription from your telephone company to activate this function. Please contact your telephone
company for this service.The phone can send and receive SMS messages (maximum 160 characters). Minimum 10
messages will be stored in the In- and Outbox.
9.1 Protocol selection
The Fidelity SMS support 2 SMS protocols (protocol 1 = default)
In the enclosed annex, a list of operators/country indicates which protocol is supported.
In case your telephone operator is not shown, contact them to know the supported protocol.
To set a protocol:
•
Remove a batterie
•
Press and hold 1 to select Protocol 1 or
•
Press and hold 2 to select Protocol 2
•
Replace the batterie
•
Release the button as soon as the protocol number is shown in the display.
Follow the instruction related to the selected protocol.
9.2 Protocol 1
9.2.1 SMS Settings
Before using the SMS function, you have to change the next settings:
•
Nr. SMS Out : Contains the telephone number of the SMS center. This number is needed to send SMS messages
towards the server.
•
Nr. SMS In : When the SMS center sends you a new message, this telephone number is send together with the
message. With this information, the telephone knows that it is an incomming SMS.
•
Terminal Number : If more SMS devices are on the same telephone line, you can give each device another
terminal number (0-9), so that SMS messages can be send to each device separately. In case the network does
not allow to use an additional Terminal Number, select ‘-’ by pressing the delete key
.
•
Delivery Mode : Depending on the networkoperator an additional digit must be sent after the Nr. SMS out and the
Terminal Number. In case the network does not support the additional Delivery mode, select ‘-’ by pressing the
delete key
.
The settings are different per country and operator. Please check the extra sheet added in this manual for different
countries (ADDENDUM) or contact your local networkoperator.
HL_FidelitySMS.book Page 10 Monday, August 4, 2003 3:38 PM