T+A Elektroakustik K1 CD-RECEIVER - Manual (Page 39)

39
Menu point 1: PLAY A-B
OK OK
START MARKER END MARKER
PL AY AB 8 PLAY AB 8
SRC OK
Introduction:
The PLAY A-B mode places two time mark-
ers on the current CD, and the machine then
repeats the passage between the two markers
constantly.
Operation:
First locate the starting point of the passage.
(     /     or     /     buttons).
Press the remote control buttons in the se-
quence shown above.
If none of the menu control buttons
(
   ,     /     or    ) are pressed
for a period of about ten seconds after pres-
sing
    button the first time, the unit
interrupts the special functions menu and
reverts to the standard display. (time-out)
The screen shows a flashing letter 'A' before
the current track number, requesting you to
enter the start marker:
'PLAY AB 08'.
flashes
Set the start marker by pressing the    
button once.
After a short delay a flashing letter 'B' ap-
pears on the screen, requesting you to enter
the end marker; press the
    button
again at the end of the passage you want to
hear repeated.
Once you have entered the end marker the
screen shows: 'PLAY AB', and the player
repeats the passage between the two markers
constantly.
You can end the repetition at any time by
pressing the
    button. The machine
then switches to STOP mode, and the screen
shows the status message 'STOP'.
Variation:
Locate the start of the sequence to be re-
peated during the normal playback process,
then press the
    button. If you now
activate the PLAY A-B point within the spe-
cial functions menu (
    button), the CD
will start automatically. You can now set the
start and end markers by pressing the

   button again.
Note:
To find the beginning or endpoints you can
use fast search backwards/forward buttons
(
 / ). Activating the PLAY A-B
mode ends REPEAT MIX or REPEAT
TRACK operation, and erases any existing
MEMO program.