T+A Elektroakustik K1 CD-RECEIVER - Manual (Page 19)

19
Menu point 4: SETUP - SETUP function 2: SETTING THE CLOCK
OK
S ETUP 10 -25 CLK
OK AMP AMP
press press
4x 1x
Introduction:
The presence of the integral clock allows you
to set the machine to switch itself on auto-
matically at a pre-programmed time. To use
this facility you must first set the clock to the
correct time. Operation:
You can change the set time by pressing the
the remote control buttons in the sequence
shown above. The screen shows the time of
day which is currently set, e.g.
'10-25 CLK'.
You can change the set time by pressing the
remote control buttons
    or    ; when
you start doing this, the word 'CLK' starts to
flash.
The time alters at three different speeds, de-
pending on the length of time you hold the
buttons pressed in.
Once you have set the time correctly, press
the
    button to store it. The screen
shows 'SET' instead of 'CLK' for one se-
cond, e.g.: '10-25 SET'
If none of the menu control buttons
(
   ,     /     or    ) are pressed
for a period of about ten seconds (or, after
changing the clock setting, for 90 seconds),
the unit interrupts the special functions menu
and reverts to the standard display. (time-out)