T+A Elektroakustik K1 CD-RECEIVER - Manual (Page 20)

20
Menu point 4: SETUP - SETUP function 3: SEPARATE VOLUME ADJUSTMENT
OK
SE TUP VO L A /B
OK AMP AMP
press press
4x 2x
Introduction:
In normal the volume of the speaker output

   A and     B are controlled in common.
If you connect an additional remote control
receiver and a pair of loudspeakers to the
speaker connections
    B (preferably in a
different living room), it is possible to adjust
the volume separately for the pairs of spea-
kers
    A und     B.
If the system is set to multi-room mode,
only the loudspeakers in the room where the
user is located are switched on; the other
speakers keep quiet.
The volume for     A can only be altered u-
sing the     buttons on the machine's
front panel, or via the integral remote control
receiver.
The volume for     B can only be adjusted via
an external remote control receiver (see also
"multi-room sound system" in the chapter
CONNECTING THE SYSTEM, THE
SYSTEM IN USE).
Operation:
To alter the option press the remote control
buttons in the sequence shown above. The
screen shows the current setting, e.g.
'VOL A/B' separate volume adjustment
(multi room sound system)
or
'VOL A+B' common volume adjustment
(single room sound system)
You can select the option with the     or
    button.
The function is terminated by pressing the

   button.
If none of the menu control buttons
(
   ,     /     or    ) are pressed
for a period of about ten seconds, the unit
interrupts the special functions menu and
reverts to the standard display. (time-out)