2 mounting the remote humidity sensor – Therma-Stor Products Group HI-E Dry Vehere User Manual

Page 4

www.thermastor.com • [email protected]

Toll-Free 1-800-533-7533

3.1D In Remote Area, Duct Inlet & Outlet
It is often desirable, to install the Vehere in an adjacent

equipment room or unfinished area. Air is then transferred

between the humid room and the unit via ducting. Remotely

mount the Vehere humidity control in the humid room and

wire to the Vehere. Local electrical codes must be followed

when wiring the control. Refer to the “Mounting the Humidity

Sensor/Controller” section which follows. (See Fig. 5)

3.2 Mounting The Remote Humidity Sensor/

3.1C In Humid Area, Duct Inlet and/or Outlet
If the pool room is very large or has high ceilings,

dehumidification can be improved by adding an inlet and/

or outlet duct to circulate and destratify stagnant areas.

Add inlet or outlet ducting to create flow across the area’s

greatest length. For areas with ceilings higher than 12’, use

an inlet duct to draw warm, moist air from near the ceiling.

See section 4.5 for attaching duct collars & ducting. (See

Fig. 4)

Dehumidistats

for

Quiet-Vent

and

remote

Vehere

Direct Warm & Dry Air

Toward Window Glass

Quiet-V

ent

Optional

Quiet-Vent

Exhaust Ventilator

Low = 165 CFM
high = 290 CFM

Vehere

Pool & Spa

Humidity Controller

Figure 4: Installation in humid area with ducting.