TOA Electronics C-CV44-3 NTSC - Manual (Page 9)

9
Camera Input/Output terminal
Monitor
: BNC plug
24 V AC or 12 V DC
Video output
Use the external power supply unit of the following rating
when the camera is operated on 12 V DC.
12 V DC, over 1.0 A
Video input
Fit the watertight cap
(shaded section)
securely to the camera.
5. Mount the water-resistant cap to the camera.
Note: If there is a gap between the water-resistant cap and the mounting surface, water can get in and
expose the connector to corrosion. To avoid equipment failures, check to be sure that the water-
resistant cap is attached correctly.
6. Connect the camera to the monitor and power supply source.
Refer to the following figure to make connections.