Top Innovations MCCULLOCH MC1246 - Manual (Page 7)

Top Innovations, Inc.
A
SSEMBLING THE
P
ORTABLE
P
OWER
S
TEAM
C
LEANER
7
CONNECTING THE STEAM JET NOZZLE
1. Align Steam Jet Nozzle with Main Nozzle as shown (FIGURE 1-A).
2. Press down on the yellow locking button located on Main Nozzle. While continuing to
hold button down, slide Steam Jet Nozzle onto Main Nozzle. Push Steam Jet Nozzle
over button, and continue to push it on unit button snaps through hole on Steam Jet
Nozzle (FIGURE 1-B).
3. To remove, press in on yellow locking button while simultaneously pulling Steam Jet
Nozzle off of Main Nozzle.
FIGURE 1
A
B
CONNECTING THE BRUSHES OR NOZZLE TIP
1. Align Brush or Nozzle Tip with Steam Jet Nozzle as shown (FIGURE 2-A). Make
sure that two side pegs on tip of Steam Jet Nozzle align with grooves inside of Brush
or Nozzle Tip.
2. Slide Brush or Nozzle Tip onto Steam Jet Nozzle, then rotate clockwise (when viewed
from front) to lock in place (FIGURE 2-B). Side pegs on Steam Jet Nozzle will be
visible through small holes in Brush or Nozzle Tip (FIGURE 2-C).
A B C
FIGURE 2