Quantum Audio Tape Library PX502 - Manual (Page 13)

PX502 Tape Library Quick Start Guide
13
5 After the library has powered down, remove the foam
restraints by completing the following steps (see
figure 20 ):
a Detach the tie band holding the two sides of the
metal restraints together and remove it from the
library.
b Remove the metal restraints from the library.
c Lift the left foam restraint slightly up and remove it
from the library.
d Slide the right foam restraint to the right until you
are clear of the robotics motor and remove the
restraint from the library.
C AUTION : Avoid touching the printed circuit board.
C AUTION : When removing the foam restraints, ensure
that the robotics umbilical cable is lying
down in the correct position inside the
platform and not across the robotics track.
Figure 20 Removing the Foam
Restraints
e Install the tape cartridge magazines.
f Close the front doors.
g If you have removed the top cover for better access,
install the top cover back on the library.
N OTE : Save the robotics restraints and re-usable tie wrap
for later shipping or relocation of the library.
N OTE : Refer to the PX500 Series User’s Guide (PN 81-
81290) for more information on loading the tape
cartridge magazines.
Tie band
Metal
restraint
Metal
restraint
Foam
restraints
Robotics
umbilical
cable