Quantum 890 USE 155 - Manual (Page 34)

Configuring the Bridge
34
3.5
Using the Configuration Menu
When the Bridge enters its configuration mode it displays its opening screen:
Schneider Automation, Inc. – Modbus Bridge (174 CEV 300 10)
Serial Number 101–161 Software Version V01.00 (990402)
Press Enter to go into Setup Mode, wait to close
At this screen, press to see the Configuration Menu.
3.5.1 Configuration Menu
The Configuration Menu shows the Bridge’s current settings. Here is an example:
Modbus Bridge Firmware Setup, Schneider Automation, Inc.
1) Network/IP Settings:
IP Address ................... 192.168.1.23
Default Gateway .............. 192.168.1.30
Netmask ...................... 255.255.255.000
2) Serial & Mode Settings:
Protocol ..................... Modbus/RTU, Slave(s) attached
Serial Interface ............. 19200,8,E,1,RS232
3) Modem Control Settings:
RTS Output ................... Fixed High/Active
4) Advanced Modbus Protocol Settings:
Slave Addr/Unit ID Source .... Modbus/TCP header
Modbus Serial Broadcasts ..... Disabled
Character, Message Timeout ... 00050 ms, 05000 ms
Commands: D)efault settings, S)ave, Q)uit without save
Select Command or Parameter (1...4) to change: __
3.5.2 Modbus Master Device: Additional Menu Items
If the serial port has already been configured for a Modbus Master device, menu item
4 will omit references to a Slave device, showing only the following:
4) Advanced Modbus Protocol Settings:
Character, Message Timeout ... 00100 ms, 05000 ms
Menu item 5 will show current mapping between Modbus addresses and IP addresses.
5) Unit ID –> IP Address Table: (followed by the current mapping table).