QSC Audio S series - Manual (Page 29)

29
Specifications
GENERAL
AC Line Voltage: 100V to 240V, auto-configuring
AC Line frequency: 50 Hz to 60 Hz, auto-configuring
Maximum AC Line Current Draw: 600 mA @ 100V
Thermal Operating Range: 0° C to 65° C
ANALOG INPUTS
Connector Type: 3-pin Phoenix (euro-style), detachable terminal block
Audio Resolution (Tx): 16, 20, 24-bit (software configurable)
Input Sensitivity: +12 dBu, +18 dBu, +24 dBu, ±0.5 dB (via internal jumper selection)
Input Impedance: >8k ohms (balanced) @ +12 dBu input sensitivity
>16k ohms (balanced) @ +18 dBu input sensitivity
>33k ohms (balanced) @ +24 dBu input sensitivity
Frequency Response: 20 Hz to 20 kHz, ±0.5 dB
Dynamic Range, typical: 108 dB FS @ 997 Hz
Dynamic Range, worst-case: >106 dB FS @ 997 Hz
Signal-to-Noise (A-weighted): 110 dB FS (20 Hz to 20 kHz), typical
THD+N @ 997 Hz: .001 %, typical
THD+N (20 Hz to 20 kHz): <.006 %, worst-case
Inter-channel Isolation: >85 dB separation
Common Mode Rejection: >50 dB (20 Hz to 20 kHz)
AES3 INPUTS
Connector Type: XLR, female
Audio Resolution: 20-bit with sample-rate-conversion
Sample Rate Support: 32 kHz, 44.1 kHz, 48 kHz
Input Impedance: 110 ohms (balanced), transformer coupled
Dynamic Range: >120 dB FS(component datasheet spec.)
THD+N (20 Hz to 20 kHz): >96 dB FS(component datasheet spec.)
ANALOG OUTPUTS
Connector Type: 3-pin Phoenix (euro-style), detachable terminal block
Audio Resolution (Rx): 16-, 20-, or 24-bit (auto-configuring)
Output Level: +6 dBu , +12 dBu, +18 dBu, +24 dBu (via internal jumper selection)
Output Level Pad: +1 dB @ 100k ohm load, typical <-.5 dB @ 600 ohm load
Maximum Load: 600 ohms minimum
Specifications Subject To Change Without Notice