QSC Audio S series - Manual (Page 22)

22
When powering up a RAVE with CobraNet version 2, the major and minor release of the firmware is displayed on the two
8-channel groups in binary format. The left group displays the major release and the right group displays the minor release.
For example, if the CobraNet version in the RAVE is 2.8.5, the left group would display a binary 8 and the right group would
display a binary 5. If a “1” indicates illumination and a “0” indicates that the LED is off, 8.5 would be displayed as “00001000
00000101” on the front-panel of the RAVE. The CobraNet version is displayed in red when the box is in hardware mode. In
this default mode, bundle assignments and configuration setup is through the front panel hexadecimal switches. The
CobraNet version is illuminated in yellow when the RAVE is in “write” mode and all configuration setup is accomplished
through the Management Interface via SNMP. In “write” mode, the “flashPersistEnable” MI variable is set and the front
panel switches are used for unit I.D.
Operation:
Audio Signal Level Indicators
AUDIO SIGNAL LEVEL INDICATORS
The tricolor metering LEDs provide visibility to various configuration and metering information. Their primary purpose is to
detect the presence of audio signal. However, the metering LEDs also perform device monitoring functions such as indicat-
ing the CobraNet firmware revision installed in the RAVE, error reporting, indicating “write” mode for MI use, indicating
“software kill”, bundle assignments and providing “bundle activity” status. For all of these device monitoring functions, the
16 metering LEDs are split into two 8-channel groups. The current signal LED indicating functions for the RAVE products
are described below.
AUDIO METERING
Each audio channel on RAVE has its own metering LED. The audio channel signal LEDs’ primary function is to provide audio
metering for each of the 16 audio channel inputs, outputs or a combination of 8 inputs and 8 outputs. In the metering mode,
the tricolor LEDs (green, yellow and red) provide an indication of the amount of signal present as well as the amount of
headroom available. The signal level at which the LED’s three colors are tripped is dependent upon the input sensitivity
selected for each channel (analog models) or the AES signal’s relation to DFS (digital full scale). Refer to the section on
sensitivity selection (p.16) for details on input levels. In relation to digital full scale, the indicators react as follows:
• Bright green—when the channel’s peak level is above -40dBFS (40dB below digital full scale).
• Yellow—when the signal peaks exceed -12dBFS
• Red—when the signal peaks reach -2dBFS and above.
During normal operation, the channel signal indicators should be flashing bright green or yellow, and perhaps once in a
while, a quick flash of red. If an LED stays dim green, the signal level is too low and you’re not taking full advantage of the
digital headroom. If an LED glows red often and for long durations, the signal level is probably too high and you’ll experi-
ence digital “clipping,” which tends to be very harsh. As with any audio device, you should consider the dynamic nature of
the program material in judging the correct level indications.
CobraNet VERSION