Quantum LTO-2 - Manual (Page 19)

Chapter 2 Installation and Quick Start
Quick Start Guide
LTO-2 Half-Height Tape Drive User’s Guide 5
Desktop LTO-2
Half-Height Tape
Drive Quick Start
2
Use the following procedure to install desktop LTO-2 Half-Height Tape
Drive. Print this page and check each step as you complete it. If you need
more information about a step, turn to the section referenced in the step.
‰ 1 Unpack the contents of your drive package, and check for damaged items.
See Unpacking and Inspection .
‰ 2 Review the drive’s default settings and change them if necessary:
• SCSI ID: 6
See Setting the SCSI ID on page 16.
‰ 3 Connect a SCSI interface cable to the drive.
See Connecting a SCSI Cable on page 16.
‰ 4 Check the SCSI termination.
See Checking the SCSI Termination on page 17.
‰ 5 Connect a power cable to the drive.
See Connecting a Power Cord on page 17.
‰ 6 • Turn on the computer
• Turn on the desktop tape drive
• Verify that the desktop tape drive is operating properly.
‰ 7 Register your tape drive.
See Registering Your Tape Drive on page 18.