To verify attached storage (solaris os) – Oracle Audio Technologies Sun StorageTek ATCA 4Gb FC Dual Port HBA SG-XPCIE2FC-ATCA-Z User Manual
Page 20
14
Sun StorageTek ATCA 4Gb FC Dual Port HBA Installation Guide • April 2010
▼ To Verify Attached Storage (Solaris OS)
1. Use the cfgadm -al command to verify attached storage.
If the HBA is properly installed and storage is connected properly, you will see
output similar to that shown in the example. In this example, one port of an HBA
adapter is connected through a fabric switch to two ports of a disk array.
2. If an adapter is shown as unconfigured, use the cfgadm -c configure
command to configure it.
% cfgadm -al
Ap_Id
Type
Receptacle
Occupant
Condition
c3
fc-fabric
connected
configured
unknown
c3::200600a0b816005e
disk
connected
configured
unknown
c3::200700a0b816005e
disk
connected
configured
unknown
c4
fc
connected
unconfigured unknown
pcie5 fibre/hp connected configured ok