SUUNTO Vector HR - Manual (Page 35)

8
detaIlS regardIng the effect of aIr temperature on altItude meaSurement are ShoWn on page 51 Of
thIS guIde.
If the AltItude Is not known, the user cAn set the seA leVel Pressure In the BArometer mode (refer to
page 40, Setting the Sea level pressure).
SettIng the Sea level preSSure WIll adJuSt the altImeter to the current altItude WIthIn approXImately
ten meterS or 30 ft. a 1-mbar change reSultS approXImately an 8-meter (or 26 ft) change In altItude, and a
0,05 inhg change reSultS a 45 ft. change In altItude.
INfOrmaTION ON The CUrreNT Sea level preSSUre CaN be ObTaINed ThrOUgh NeWSpaperS, lOCal NeWS aNd
radIo Weather reportS, the local aIrport facIlIty or through the Internet under local Weather.
4.1 seTTIng THe alTIMeTeR
In setting the Altimeter, there are three processes that can be performed: the Reference Altitude (known altitude at the current location);
Altitude Alarm (signals the user when a certain altitude, programmed, is reached); and Logbook Recording Interval (allows the user to
view the altitude, average rate of vertical movement and heart rate within a chosen interval of time).
. press the [select] button and hold in for seconds. located in field is the text “re” (indicating reference altitude), located in
Field 2, the current altitude will begin to flash (Fig. 22).
. press the [+] button to scroll the altitude upward or press the [-] button to scroll the altitude downwards.
3. at the desired reference altitude, either press the [mode] button to accept the changes and return to the main mode or press
the [Select] button to move to the next setting. Located in Field 1, the “ON” or “OFF” will begin to flash (Fig. 23).
4. press either the [+] or the [-] button to toggle between the “on” and “off” for the altitude alarm.
5. at the desired setting, press the [select] button to move to the next setting. located in the center of field , the alarm altitude
will begin to flash.
6. press the [+] button to scroll the altitude upward or press the [-] button to scroll the altitude downwards.
7. at the desired altitude, either press the [mode] button to accept the changes and return to the main mode or press the [select]
button to move to the next setting. Located in Field 1, the text INT and located in Field 2 the time interval will begin to flash (Fig.
4).
8. PRESS either the [+] or the [-] button to scroll through the intervals. There are four time intervals: 20 seconds, 1 minute, 10 minute
or 60 minutes.