Onkyo TX-SR508 - Manual (Page 48)

48
En
Controlling Zone 2 with the Remote
Controller
Note
• To control Zone 2, you must press the remote controller’s
ZONE2 first.
Adjusting the Volume for Zone 2
■
Operating with the remote controller
■
Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the
volume.
Muting Zones
■ Operating with the remote controller
To unmute a zone
Note
• Only analog input sources are output by the ZONE 2 LINE
OUT and FRONT HIGH OR ZONE2 L/R speaker terminals.
Digital input sources are not output. If no sound is heard when
an input source is selected, check if it’s connected to an analog
input.
• While Powered Zone 2 is being used, listening modes that
require surround back and front high speakers (6.1/7.1), such as
Dolby Pro Logic IIz Height, Dolby Digital EX, and DTS-ES are
unavailable.
• While Zone 2 is on, functions will not work.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same FM/AM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
1
Press ZONE2, and then press ON/STANDBY.
Zone 2 turns on, the ZONE 2 indicator lights.
2
To select an input source for Zone 2, press
ZONE2, followed by an INPUT SELECTOR.
To select AM or FM press the TUNER input selector
repeatedly.
(North American models) You can also select SIR-
IUS.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press ZONE2 followed by ON/
STANDBY.
ON/STANDBY
INPUT SELECTOR
MUTING
VOL /
ZONE2
1
Press ZONE2
2
Use VOL /
1
Press ZONE 2 (the ZONE 2 indicator and Zone 2
selector on the display flashes)
2
Use –/+ within 8 seconds
1
Press ZONE2
2
Press MUTING
1
Press ZONE2
2
Press MUTING again