Omnimount Power55 - Manual (Page 35)

P35
REMOTE CONTROL PROGRAMMING
(English)
LEFT SWIVEL
RIGHT SWIVEL
TILT UP
MEMORY 1:
Hold for 5 Seconds until
LED LIGHT color turns
sold, memory is set
Move to another desired
location and repeat above
step to memorize again.
STEP 1
WALL DETECT RIGHT
Swivel to the closest to the
Wall without the TV
touching the Wall, leave
about 1” (25mm) of space
recommended, Hold down
Wall Detect for 5 seconds
till LED LIGHT color turns
solid
LED LIGHT
Flashing LED: Transmitting Signal
Solid Color LED: Memory Set or Cancelled
STEP 2
WALL DETECT LEFT
Swivel to the closest to the
Wall without the TV
touching the Wall, leave
about 1” (25mm) of space
recommended, Hold down
Wall Detect for 5 seconds
till LED LIGHT color turns
solid
SETUP:
Push / Collapse the Wall Mount Flat against
the Wall, Press and Hold for 5 seconds to
set the home position (note: this also clears
all memorized commands)
RESET: Hold for 5 seconds to clear all
commands and memorize HOME position.
ATTENTION!
Must set WALL DETECT RIGHT first. Failure to do this may result in poor performance of Wall
Mount. If set LEFT WALL DETECT, please use the SETUP / RESET to clear memory
MEMORY 2:
Hold for 5 Seconds until
LED LIGHT color turns
sold, memory is set
Move to another desired
location and repeat above
step to memorize again.
TILT DOWN
HOME
This will bring the wall
mount back to the wall of
HOME position that user
setup, if user needs to set
a different Home position,
please refer to SETUP
button above for details.
ATTENTION!
Power Loss or interruption DOES NOT delete or clear the memory. User
must use the SETUP / RESET button to clear memory.
If Swivel too far RIGHT or LEFT and hits / makes contact with the wall, the
unit will Stop after 2 seconds.
8