SUUNTO D4 - Manual (Page 78)

CAUTION!
•
Do not use compressed air to blow water off the unit.
• Do not use solvents or other cleaning fluids that might cause damage.
• Do not test or use the dive computer in pressurized air.
• WATER RESISTANCE INSPECTION
The water resistance of the unit must be checked after replacing the battery or
after other service operations. The check requires special equipment and training.
You must frequently check the display for any sign of leaks. If you find moisture
inside your dive computer, there is a leak. A leak must be corrected without delay
as moisture will seriously damage the unit, even beyond repair. SUUNTO does
not take any responsibility for damage caused by moisture in the dive computer
unless the instructions of this manual are carefully followed. In the event of a leak,
immediately take the dive computer to an authorized SUUNTO dealer or distributor.
FAQs
WHAT CAN I DO TO MY SUUNTO DIVING COMPUTER MYSELF?
NOTE It is advisable to contact an authorized Suunto service, distributor
or retailer for any repairs. Batteries and straps can be replaced
by the user when the change is made in a proper manner to avoid
any leakage of water into the battery compartment or computer.
Original battery replacement and strap kits must be used.
Batteries can be changed by the user in all diving computers except Stinger, D4, D6
and D9.
Instructions for changing batteries and straps can be found in the user manuals or at
www.suunto.com and the user videos there.
79