One for All URC-7010 - Manual (Page 11)

W W W.ONEFORALL.COM
11
Trouble-Shooting
Problem:
Your brand is not listed in the
code section?
The ONE FOR ALL does not
operate your device(s)?
The ONE FOR ALL is not
performing commands
properly?
Problems changing channels?
The ONE FOR ALL does not
respond after pressing a key?
The red light does not blink
when you press a key?
Solution:
Try the search method on page 7.
A) Try all the codes listed for your
brand.
B) Try the search method on page 7.
You may be using the wrong code. Try
repeating the Direct Set-Up using
another code listed under your brand
or start the search method over again
to locate the proper code.
Enter the programme number exactly
as you would on your original remote.
Make sure you are using new batteries
and are aiming the ONE FOR ALL at
your television.
Replace batteries with 2 fresh, new
“AA/LR6” alkaline batteries.
ONE FOR ALL Recall (Previous Channel)
If your television has a Recall or Previous / Last Channel function, the Recall
key allows you to access this function. If, however, your television does not
have a Recall or Previous / Last Channel function, then you can set up your
own two favourite channels with the ONE FOR ALL Recall function.
The ONE FOR ALL Recall function allows you to program up to two channels,
each consisting of a maximum of 4 key presses per channel entry. This allows you
to swap back and forth between two channels with the press of a single key.
1 Press the MAGIC and RECALL keys simultaneously, until the red
light blinks twice.
2 Enter the first channel number exactly as you would on your
original remote (e.g. <-/-->, <1>, <2> to get channel number 12).
3 Press RECALL once and release.
4 Enter the second channel number exactly as you would on your
original remote (e.g. <-/-->, <2>, <3> to get channel number 23).
5 Press the MAGIC key, and the red light blinks twice.
Now, if you press RECALL, you will obtain the second channel programmed
(being <23>) and if you press RECALL again you will obtain the first chan-
nel programmed (being <12> in our example).
To reset the RECALL key:
1 Press MAGIC and RECALL simultaneously until the red light
blinks twice.
2 Press RECALL and release.
3 Press MAGIC and release and the red light will blink twice.
Important notes:
- To enter only one channel number, skip steps 3 & 4.
- If two channel numbers have been stored previously, entering one new
channel will delete the oldest entry.