Odyssey Electronics Building Set - Manual (Page 14)

14
Assign a new ID# to your
Command-equipped
locomotive
Set the locomotive PROGRAM/RUN
Switch to PROGRAM (see illustration)
Command Base ON
Place the locomotive on track
PowerMasters set to CMD or traditional
power supplies ON FULL
Turn track power on (PowerMasters):
Press BOOST
Program the locomotive with a new ID#:
Press ENG
Press a number you choose
(the ID#)
Press SET
Set PROGRAM/RUN Switch to RUN
(see page 4 for location)
Your locomotive remembers its ID#
forever; change it any time with these
steps.
Example
A s your fleet of Command-
equipped Lionels grows, give
your locomotive its own ID#. Choose
from any between 1 and 99. Slide
the locomotive’s PROGRAM/RUN
switch to PROGRAM. Plug-in the
Command Base and place the loco-
motive on track. Then, power up.
Using CAB-1, press ENG, the loco-
motive ID#, then press the SET but-
ton located under CAB-1’s removable
panel. See the locomotive’s head-
light flash; that’s your signal that
the programming has been accept-
ed. Now slide the switch to RUN.
We recommend that you choose an easy-to-
remember ID# for your locomotives. Some
possibilities are part of the locomotive road
number, your age, or any two-digit number
that is not used by another locomotive. If
you like, write the number on a small piece
of tape and put this on the bottom of the
frame to aid in remembering.
Assigning your locomotive a new ID#
TrainMaster Command operations
Program/Run Switch
Smoke Unit Switch
Rear