Omega Engineering DP3600 - Manual (Page 19)

18
A
1
2 3
4
3
B
3.62" (91.9mm)
1.70"
43.2mm
NOT DRAWN TO SCALE
Back of
the Meter
Bracket
Screw Driver
Push Meter this way
with the Screwdriver
MOUNTING
1. Cut a hole in panel to the specifications
shown in the figure 4:
Figure 4. Panel Cutout Dimensions
2. Insert pannel meter into the hole until it is flush with
the pannel.
3. Refer to Figure 5. Losen the wing nuts (3) on the two
screws (2) on the bracket. You don't have to remove the
screws.
4. Slide the open end (A) of the bracket onto the meter
until it is flush with the panel. The rear of the meter
should touch the back of the bracket (B).
Figure - 5. Mounting Bracket Assembly
5. Tighten the wing nuts. Check
that the meter is secure against the
panel. If not, use a screwdriver and
slip it into the slot between the
bracket and the meter (refer to
Figure 6 below to locate the spot
where the screwdriver should go)
and push the meter back with the
screwdriver to reduce the gap
between the meter and the panel.
This will insure a tight fit for the
panel meter.
Figure - 6. Screwdriver Placement
-- Side view of mounting bracket