Omega Engineering DP3600 - Manual (Page 11)

10
SET UP FLOW CHART:
SETUP
SCALING
(SCALING)
HIGH SCALE
(HI SCLE)
LOW SCALE
(LO SCLE)
OFFSET
(OFFSET)
TARE
(TARE)
PROGRAM PROCESS LIMIT 1
(PrG Lt1 -- 01.234)
PROGRAM PROCESS LIMIT 2
(PrG Lt2 -- 01.234)
LIMIT 3 RATE OR PROCESS
(Lt3 rtE) or (Lt3 Pr)
PROGRAM LIMIT 3 VALUE
(PrG Lt3 -- 02.123)
LIMIT4 PROCESS / DEVIATION
(Lt3 dEN) or (Lt3 Pr)
TIMER 1 LIMIT
(tr 1 Lt -- 00012)
PROGRAM LIMIT 4 VALUE
(PrG Lt4 -- 01.123)
DISPLAY OPTION
(dSP Opt)
1. PrOCESS
2. SP dEn
3. RAtE
4. Pr CnG
5. HIGH Pt
6. LO Pt
7. ELPSd t
8. SCAn
INPUT RANGE
(IP rnGE – 020.00)
REMOTE TARE/HOLD
(rt tArE -- rt HOLD)
PROGRAM SETPOINT
(SetPt -- 1.234)
INPUT TYPE
(IP tYPE)
1. CurrEnt
2. VOLtAGE
3. LO VOLT
FLASH TIME
(FLASH t -- 00015)
ENGINEERING UNITS
(EG UNIT -- PSI)
PROGRAM SYSTEM
(PrG SYS)
TIMER 2 LIMIT
(tr 2 Lt -- 00012)
DEAD-BAND FOR LIMITS
(dEAdbd -- db 00012)
LT1 NORMALLY OPEN/CLOSE
(Lt1 n.O. or Lt1 n.C.)
LT2 NORMALLY OPEN/CLOSE
(Lt2 n.O. or Lt2 n.C.)
AUDIO ALARM ON/OFF
(ALr On -- Alr OFF)
LATCH OR NON-LATCH MODE
(LATCH -- nOn LCH)
LT4 NORMALLY OPEN/CLOSE
(Lt4 n.O. or Lt4 n.C.)
LT3 NORMALLY OPEN/CLOSE
(Lt3 n.O. or Lt3 n.C.)
PROGRAM LIMITS
(PROG Lt)