Oricom P700 - Manual (Page 17)

17
2. Press OK to select.
3. Press to listen to and select from the 5 melodies.
4. Press OK to confirm your selection and you will be prompted to
volume Setting.
5. Press to listen to and select from the different volume
levels.
6. Press OK to confirm your selection.
You have the option to turn off the base ringer.
You cannot program the base ringer if the handset has lost link with the
base. UNAVAIL will be displayed. Re-establish the link and try again.
Recall duration
When you are talking on the phone, pressing
will send a flash signal.
There are 2 factory programmed recall timings for you to choose from.
Check with your local telephone company if you are not sure which
duration to set and the functions performed with the flash signal.
1. Press
PROG during standby and press until you see
flashing.
2. Press OK to select. The current duration is now displayed.
3. Press 1 or 2 directly or press to select.
4. Press OK to confirm.
Register
Each handset can register to one base at a time only. The current base
will be deregistered when a new base is registered.
Each base can register up to 4 handsets.
1. Press PROG during standby and press or until you
see icon flashing.
2. Press OK to select.
3. Before you enter the PIN, press and hold on the base for 2
seconds until a registration tone is emitted. The base is now in the
registration mode. (If the base is full and cannot take on any more
handset, it will emit a reject tone instead. See the section of
Deregister to delete a currently registered handset.)
4. Enter the PIN of the base and press OK .