Olympus Stylus Tough-8010 EN - Manual (Page 50)

50 EN
To operate images with the TV remote control
1 Set [HDMI CONTROL] to [ON], and turn off the camera.
2 Connect the camera and TV with an HDMI cable. “Connection via HDMI cable” (p. 49)
3 First turn on the TV, and then turn on the camera.
Operate by following the operation guide that is displayed on the TV.
With some TVs, operations cannot be performed with the TV remote control even though the
operation guide is displayed on the screen.
If operations cannot be performed with the TV remote control, set [HDMI CONTROL] to [OFF] and
operate using the camera.
Saving battery power between shots [POWER SAVE]
t (Settings 3) X POWER SAVE
Submenu 2 Application
OFF Cancels [POWER SAVE].
ON
When the camera is not being used for approx. 10 seconds, the monitor automatically turns
off to save battery power.
To resume standby mode
Press any button.
Displaying the current altitude/water depth (atmospheric/hydraulic pressure)
[MANOMETER]
(STYLUS TOUGH-8010/ μ TOUGH-8010 only)
t (Settings 3) X MANOMETER
The readings may have a margin of error depending on meteorological conditions. Use the readings
only for your reference.
Submenu 2 Submenu 3 Application
MANOMETER
OFF Cancels the manometer display.
ON
Displays the current altitude/water depth (atmospheric/hydraulic
pressure) in the shooting standby mode screen. (–10 m to 5,000 m)
CALIBRATE Proceed to the setting screen. See below.
m/ft
m This displays in meters.
ft This displays in feet.
When set to [ON], a warning message appears in the monitor as a water depth close to 7 m (22.9 ft)
is reached.
●