General options, Reset to factory defaults, Appendix a – Opticon LH2 User Manual
Page 41
Appendix
A
40
General Options
41
General Options
Command Name: Reset to Factory Defaults
Usage:
Use this option to reset the imager to RS232 factory defaults.
Description:
This command will set the imager to factory defaults. This command
is extremely helpful if you have set the imager to different settings
and want to erase those settings and reset the imager back to the
factory defaults. It does not erase the Clear Prefix & Suffix
commands.
Default:
ON
Programming Code:
Serial Command:
J<┘
P%1b1<┘
P%420<┘
P%081<┘
Note:
This code does not reset the Prefix & Suffix settings to factory
defaults. In order to reset the Prefix & Suffix settings to factory
defaults, use the “Erase Prefix” and “Erase Suffix“ commands.
Options:
---