Onkyo DR-S2.2 - Manual (Page 69)

69
DISPLAY ENTER
Prog. Memory
Move Select
Off 1 2 3
Check
■ Adjusting the picture quality settings
– To create your own setting (2)
1 Use the cursor button ( 3) to select [Start] then press
ENTER.
Memory
DNR
Sharpness
Detail
Chroma Delay
Gamma
min max
min max
off max
green red
Off
On Off
1 2 3
Interlace Video Memory Select
Interlace Video Setup
(North American model when set to [Interlace] setting in
the Setup screen Video 1 menu, and other models)
Fine Focus
Switch [On] to reveal greater detail (higher resolution) in the
picture
Contrast
Adjusts the contrast of the elements in the picture.
Sharpness
Adjust the sharpness of the high-frequency (detailed) elements in
the picture. (This setting is only effective when [Fine Focus] is
[On].)
Chroma Level
Adjusts how saturated colours appear.
Hue
Adjusts the overall red/green color balance.
Memory (Interlace Memory)
Program the current settings.
5 Use the cursor buttons ( 2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
6 Repeat steps 4 and 5 to make adjustments to other
settings.
If you would like to save the settings in the player’s memory, be
sure to select either [1], [2], or [3] in the [Prog. Memory] or
[Memory (Interlace Memory)] setting to establish which memory
location to save the new settings in. Please note that if you select
a location where settings have already been saved, the old
settings will be replaced by the new ones.
2 Use the cursor button ( ∞) to select [Video Setup] and press
ENTER.
3 Press DISPLAY.
4 Use the cursor buttons ( 5/∞) to select the setting and use
the cursor buttons ( 2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes
immediately.
5 To memorize the setting, select Memory 1, 2, 3, then press
ENTER.
The previous setting will be erased.
7 When you are finished making adjustments, press ENTER
to establish the new settings.