Olympus MAUSB-10 - Manual (Page 9)

9
1. Double-click “My Computer”.
<98/98 SE/Me
ࡗInstall>
2. Right-click “OLYMPUS”. Select “Open” from the
pop-up menu.
4. Double-click “SETUP”.
* The “OLYMPUS USB Reader/Writer
InstallShield Wizard” window appears. Start
installing by following “Install the device driver”
(
੬
p. 7).
1. Disconnect the MAUSB-10 from the computer
(
੬
p. 15).
2. Click the “Cancel” button.
3. Place the CD-ROM into the CD-ROM drive.
Follow the instructions in “Install the device
driver” (
੬
p. 7).
If the installation window does not appear when the CD-ROM is loaded
Follow the steps below to specify the file and start installing.
When the “Add New Hardware Wizard” window appears
If you connect the MAUSB-10 to the computer
before installing the device driver, the “Add New
Hardware Wizard” window appears. In this case,
follow the steps below.
3. Double-click “Mausb_10”.