One for All 6-Device Universal Remote User Manual

Page 18

WNER

’

ANUAL

Troubleshooting 17

SOLUTION:

Make sure the remote
control is aimed at your
home entertainment
device and is not farther
than 15 feet away.

PROBLEM:

The unit does not control
home entertainment
devices or commands are
not working properly.

SOLUTION:

Try all listed codes for the
device brands being set
up. Make sure they can be
operated with an infrared
remote control.

PROBLEM:

TV/VCR Combo does not
respond properly.

SOLUTION:

Use the VCR codes for your
brand. Some combo units
may require both a TV code
and a VCR code for full
operation.

PROBLEM:

Changing channels does
not work properly.

SOLUTION:

If the original remote
control required pressing
ENTER to change channels,
then press ENTER on the
remote control after
entering the channel
number.

PROBLEM:

During learning, LED
emits a long blink after
pressing and holding key
to be learned.

SOLUTION:

Memory is full or a bad
capture has occurred.
Avoid high-ambient light
sources, such as direct
daylight and fluorescent
bulbs. Try readjusting
positions of remote
controls before performing
the procedure again.

PROBLEM: Tried

Searching For Your

Code method and still
could not find a working
code.

SOLUTION:

Clear the device key as
follows: Press and hold SET
until the LED (red light)
blinks twice, then
release.Next enter 9 9 2.
Then press the device key
to be cleared twice.Now
repeat the Searching for
Your Code method on page
8.

PROBLEM:

CH+ and CH- do not work
for your RCA TV.

SOLUTION:

Due to RCA design (1983-
1987), only the original
remote control will operate
these functions.

PROBLEM:

No remote control of
volume.

SOLUTION:

See “Changing Volume
Lock” on page 15 to lock/
unlock volume.

OFA 6L with Learning Owners Manual.fm Page 17 Thursday, February 17, 2005 1:10 PM