One for All 6-Device Universal Remote - Manual (Page 15)

O NE F OR A LL 6L U NIVERSAL R EMOTE C ONTROL WITH L EARNING
14 Using Keymover
You can also re-assign another unused
device key by substituting an open key for
the VCR key in the above chart and
performing the sequence. For example, to
re-assign an unused CBL/SAT key as a 2nd TV
key, perform SET - 9 - 9 - 2 - TV -
CBL/SAT. When a re-assignment is done, the
LED (red light) will blink twice to confirm
your choice. At that time, you will need to
program the remote control for the new
device (see “Setting Up Your Components”
on page 7).
USING KEYMOVER
The One For All 6L Universal Remote
Control with Learning (URC-6820 B00)
includes a Keymover feature that allows you
to map (or copy) keys from one mode (i.e.,
source mode) to another mode (i.e.,
destination mode).
NOTE: The following keys cannot be used as a
source or destination: TV, CBL/SAT, VCR, DVD,
PVR, AUD, FAV, and SET.
P ROGRAMMING K EYMOVER
For example, if your VCR does not have
volume control, you can map those keys
(i.e., VOL +, VOL -, and MUTE) from the TV
mode to the VCR mode as follows:
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 4. The LED will blink twice.
3. For the source mode, press TV once.
4. For the source key, press VOL + once.
5. For the destination mode, press VCR
once.
6. For the destination key, press VOL +
once.
7. The LED will blink twice, indicating
the keymoved sequence is correct.
8. Repeat steps 1 through 7 twice more to
map remaining volume control keys,
substituting VOL - and MUTE as source
and destination keys in steps 4 and 6.
Upon completion of the above procedure,
you can now use your One For All 6L
Universal Remote Control with Learning
(URC-6820 B00) to control the TV’s volume
and MUTE in the VCR mode, as well as in the
TV mode.
R ESTORING K EYMOVED K EYS TO D EFAULT
S ETTINGS
Restoring a Single Keymoved Key
1.
Press a device key that has a keymoved
key.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 4. The LED will blink twice.
4. Press the destination key twice (where
the keymoved key is stored). The LED
will blink twice.
Restoring All Keymoved Keys in a Single
Mode
1.
Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 4. The LED will blink twice.
3. Press the destination mode twice
(where keymoved keys are stored). The
LED will blink twice.
VCR as 2nd
TV key: SET - 9 - 9 - 2 - TV -
VCR
VCR as 2nd
CBL/SAT key: SET - 9 - 9 - 2 -
CBL/SAT - VCR
VCR as 2nd
PVR key: SET - 9 - 9 - 2 - PVR -
VCR
VCR as 2nd
AUD key: SET - 9 - 9 - 2 - AUD -
VCR
OFA 6L with Learning Owners Manual.fm Page 14 Thursday, February 17, 2005 1:10 PM